Ultra high efficiency fan shroud for use with a 30mm fan. Weight is just over 3 gram. Mounts using 2.5mm supplied hardware, to the motor mount backbone. Motor to cooling fan spacing is approx 11.5mm, to avoid magnetic interference. Proven temperature reductions of up to 20*f. For additional cooling efficiency we recomend the AC 30mm Inlet with AC 30mm Fan
*Fan NOT included*
Necessary hardware included consists of
(4) M3x12mm BHS
(2) M2.5x8mm BHS
(2) M2.5mm washer
*When installing fan shroud, begin by threading 2.5mm screws with washers, on first. Thread screws in a couple turns, maintaining enough clearance for fan shroud to slide into position. Once slid into position, and adjusted, tighten mounting screws from rear of vehicle, using 1.5mm driver. Ball end drivers allow slightly easier access, where working space is limited.